EDUCATION AND ASSISTANCE FUND 18.01 The Employer shall contribute to the Union’s Education and Assistance Fund the amount identified at Schedule “A” for each hour worked by each employee covered by this Agreement, and shall remit such contributions to the Union together with union dues, and in the manner described in the Remittances to the Union article and in the Union’s remittance directive.
Cooperation and Assistance (i) The Parties shall cooperate with each other in the filing of any Tax Returns and the conduct of any audit or other proceeding. They each shall execute and deliver such powers of attorney and make available such other documents as are reasonably necessary to carry out the intent of this Section 6.14.
License and Association Membership Dealer’s acceptance of this Participating Dealer Agreement constitutes a representation to the Company and the Dealer Manager that Dealer is a properly registered broker-dealer under the Exchange Act, is duly licensed as a broker-dealer and authorized to sell Shares under Federal and state securities laws and regulations and in all states where it offers or sells Shares, and that it is a member in good standing of FINRA. Dealer agrees to notify the Dealer Manager immediately in writing and this Participating Dealer Agreement shall automatically terminate if Dealer ceases to be a member in good standing of FINRA, is subject to a FINRA suspension, or its registration as a broker-dealer under the Exchange Act is terminated or suspended. Dealer hereby agrees to abide by all applicable FINRA Rules, including, but not limited to, FINRA Rule 2310. Dealer Manager represents and warrants that it is currently, and at all times while performing its functions under this Participating Dealer Agreement will be, a properly registered broker-dealer under the Exchange Act and under state securities laws to the extent necessary to perform the duties described in this Participating Dealer Agreement, and that it is a member in good standing of FINRA. The Dealer Manager agrees to notify Dealer immediately in writing if it ceases to be a member in good standing with FINRA, is subject to a FINRA suspension, or its registration as a broker-dealer under the Exchange Act is terminated or suspended. The Dealer Manager hereby agrees to abide by all applicable NASD Conduct Rules under FINRA and other applicable FINRA Rules, specifically including, but not limited to, FINRA Rule 2310.
FDIC Open-Bank Assistance All obligations under this Agreement shall terminate, except to the extent determined that continuation of the contract is necessary for the continued operation of the Bank, when the Federal Deposit Insurance Corporation enters into an agreement to provide assistance to or on behalf of the Bank under the authority contained in Federal Deposit Insurance Act section 13(c). 12 U.S.C. 1823(c). Rights of the parties that have already vested shall not be affected by such action, however.
Governance and Anticorruption 14. The Borrower, the Project Executing Agency, and the implementing agencies shall (a) comply with ADB’s Anticorruption Policy (1998, as amended to date) and acknowledge that ADB reserves the right to investigate directly, or through its agents, any alleged corrupt, fraudulent, collusive or coercive practice relating to the Project; and
Information and Assistance 15.1.1 Subject to any obligation in respect of confidentiality, the Data Protection Legislation and Confidential Information, the Parties will use all reasonable endeavours to provide and share information and data reasonably required by the other:
Anti-Corruption and Anti-Bribery Laws Neither the Company nor any of its subsidiaries nor any director, officer, or employee of the Company or any of its subsidiaries, nor to the knowledge of the Company, any agent, affiliate or other person acting on behalf of the Company or any of its subsidiaries has, in the course of its actions for, or on behalf of, the Company or any of its subsidiaries (i) used any corporate funds for any unlawful contribution, gift, entertainment or other unlawful expenses relating to political activity; (ii) made or taken any act in furtherance of an offer, promise, or authorization of any direct or indirect unlawful payment or benefit to any foreign or domestic government official or employee, including of any government-owned or controlled entity or public international organization, or any political party, party official, or candidate for political office; (iii) violated or is in violation of any provision of the U.S. Foreign Corrupt Practices Act of 1977, as amended (the “FCPA”), the UK Xxxxxxx Xxx 0000, or any other applicable anti-bribery or anti-corruption law; or (iv) made, offered, authorized, requested, or taken an act in furtherance of any unlawful bribe, rebate, payoff, influence payment, kickback or other unlawful payment or benefit. The Company and its subsidiaries and, to the knowledge of the Company, the Company’s affiliates have conducted their respective businesses in compliance with the FCPA and have instituted and maintain policies and procedures designed to ensure, and which are reasonably expected to continue to ensure, continued compliance therewith.
TEACHING LOADS AND ASSIGNMENTS A. The normal daily/weekly teaching load shall be:
CFR PART 200 Domestic Preferences for Procurements As appropriate and to the extent consistent with law, the non-Federal entity should, to the greatest extent practicable under a Federal award, provide a preference for the purchase, acquisition, or use of goods, products, or materials produced in the United States (including but not limited to iron, aluminum, steel, cement, and other manufactured products). The requirements of this section must be included in all subawards including all contracts and purchase orders for work or products under this award. For purposes of 2 CFR Part 200.322, “Produced in the United States” means, for iron and steel products, that all manufacturing processes, from the initial melting stag through the application of coatings, occurred in the United States. Moreover, for purposes of 2 CFR Part 200.322, “Manufactured products” means items and construction materials composed in whole or in part of non-ferrous metals such as aluminum, plastics and polymer-based products such as polyvinyl chloride pipe, aggregates such as concrete, class, including optical fiber, and lumber. Pursuant to the above, when federal funds are expended by ESC Region 8 and TIPS Members, Vendor certifies that to the greatest extent practicable Vendor will provide a preference for the purchase, acquisition, or use of goods, products, or materials produced in the United States (including but not limited to iron, aluminum, steel, cement, and other manufactured products). Does vendor agree? Yes
200 Domestic Preferences for Procurements As appropriate and to the extent consistent with law, the non-Federal entity should, to the greatest extent practicable under a Federal award, provide a preference for the purchase, acquisition, or use of goods, products, or materials produced in the United States (including but not limited to iron, aluminum, steel, cement, and other manufactured products). The requirements of this section must be included in all subawards including all contracts and purchase orders for work or products under this award. For purposes of 2 CFR Part 200.322, “Produced in the United States” means, for iron and steel products, that all manufacturing processes, from the initial melting stag through the application of coatings, occurred in the United States. Moreover, for purposes of 2 CFR Part 200.322, “Manufactured products” means items and construction materials composed in whole or in part of non-ferrous metals such as aluminum, plastics and polymer-based products such as polyvinyl chloride pipe, aggregates such as concrete, glass, including optical fiber, and lumber. Pursuant to the above, when federal funds are expended by ESC Region 8 and TIPS Members, Vendor certifies that to the greatest extent practicable Vendor will provide a preference for the purchase, acquisition, or use of goods, products, or materials produced in the United States (including but not limited to iron, aluminum, steel, cement, and other manufactured products). Does vendor agree? Yes
