Reinspection. Prior to an Owner reoccupying the subject property or Owner initiating any repairs or maintenance while this Agreement is in effect, a joint inspection by the Owner, and Agent will be made, unless Owner is unavailable.
Reinspection. Request reinspection when the Work identified in previous inspections as incomplete is completed or corrected.
Reinspection is a type of inspection that is required when during a routine inspection risk/critical violations are noted on the inspection report that cannot be corrected onsite or when consecutive repeat violations are noted on past inspection reports. Reinspections are required inspections to assure that violations have been corrected. Fees are associated with type of inspection.
Reinspection. Xxxxxx agrees to pay CRMC the sum of $175.00 for each re-inspection of the Premises if any one or more of the following circumstances occur: 1) Lessee elects to perform the repairs to the Premises in preparation for the inspection rather than permit CRMC to perform repairs. 2) There is an infraction that requires re-inspection that the City deems to be a tenant issue. 3) Damage occurs to the Premises after CRMC performs repairs in preparation for such inspection.
Reinspection. A visual or mechanical/physical evaluation performed to remove/correct defective units for which the process is not expected to have an adverse effect on Product quality.
Reinspection. Reinspection of questioned Work may be ordered by the Owner, and if so ordered, the Work must be uncovered by the Contractor. If such Work is found to be in accordance with the Contract Documents, the Owner shall pay the cost of reinspection and replacement. If such Work is found not to be in accordance with the Contract Documents, the Contractor shall pay such cost.
Reinspection. You will promptly cure any problems with the Equipment that are discovered during our inspection. o You will use the Equipment only for business purposes. You will obey all legal and regulatory requirements in your use of the Equipment. o You will make all additions, modifications and improvements to the Equipment that are required by law or government regulation. Otherwise, you will not alter the Equipment without our written permission. You will replace all worn, lost, stolen or destroyed parts of the Equipment with replacement parts that are as good or better than the original parts. The new parts will become our property upon replacement. o You will not remove the Equipment from the location indicated in the Schedule without our written permission.
Reinspection. Whenever the Committee has reason to believe that peanuts may have been damaged or deteriorated while in storage, the Committee may reject the then effective inspection certificate and may require the owner of the peanuts to have a reinspection to establish whether or not such peanuts may be disposed of for human consumption. (f) Further modification of § 998.32. (1) The provisions of § 998.32(a) restricting the disposition of peanuts which fail to meet the requirements specified heretofore in this section to the Commodity Credit Corporation or in such manner as may be prescribed by the Committee with the approval of the Secretary, is hereby modified to specify that only peanuts which have been certified as meeting the requirements specified in paragraphs (a) or (b) of this section, which have been sampled pursuant to paragraph (c) of this section, and which have been identified pursuant to paragraph (d) of this section are eligible for disposition to human consumption outlets. (2) Lots of peanuts which have not been certified as meeting the requirements for disposition to human consumption outlets, may be disposed for non-human consumption uses which are not regulated or limited by the provisions specified hereinafter in this section: Provided, That each such lot is positive lot identified, using red tags, and certified as to aflatoxin content (actual numerical count). However, on the shipping papers covering the disposition of each such lot of inedible quality peanuts, the handler shall cause the following statement to be shown: “The peanuts covered by this bill of lading (or invoice, etc.) are not to be used for human consumption.” (3) Except for inedible quality peanuts disposed of under the provisions of paragraph (f)(2) of this section and peanuts derived from the milling for seed of Segregation 2 and 3 farmers stock peanuts, peanuts which have not been certified as meeting the standards set forth in paragraphs (a) or (b) of this section shall be disposed of as prescribed hereinafter in this section. (g) Xxxxxxx oil stock residuals—for crushing or export. Peanuts and portions of peanuts which are separated from edible quality peanuts by screening or sorting or other means during the milling process, may be segregated into categories or commingled as xxxxxxx oil stock residuals. Such xxxxxxx oil stock residuals shall be identified pursuant to paragraph (d) of this section, but using a red tag, and such peanuts may be disposed of domestically or to the...
Reinspection. All rework or repaired product must be re inspected in accordance with documented procedures prior to release.
Reinspection. (1) At least once every 3 years after a management plan is in effect, each local education agency shall conduct a reinspection of all friable and nonfriable known or assumed ACBM in each school building that they lease, own, or otherwise use as a school building. All work will be performed by USEPA/NYSDOL accredited personnel. Collection of additional bulk samples of suspect materials is not anticipated. A report will be issued at the completion of the project identifying assessments, reassessments and the general findings of the reinspection. Our work will be limited to accessible areas. We cannot explore walls or ceiling areas to which we have no access unless, of course, demolition takes place. Exterior building materials, including window caulk/glazing compounds and roofing materials are not identified in the AHERA testing protocol and will not be sampled unless specifically requested by the Owner. A detailed report will be provided to the Xxxxxx Central School District with our observations and recommendations where appropriate. We assure you that the reinspection will be thorough and will meet your needs. Xxxx Xxxxxx will lead IBI Group’s efforts in completing the work. If you should have any questions regarding the work scheduled, please feel free to call Xxxx at (000) 000-0000. IBI Group Architects, Engineers and Landscape Architects, a New York Partnership is a member of the IBI Group of companies The Lump Sum proposed for providing the referenced scope of work is $6,800.00, plus direct project related expenses. An invoice for the services rendered will be issued upon completion of the work. Invoices are due and payable within thirty days of invoice date. Should you be in agreement with our proposal, we will prepare a Consulting Services Agreement for your approval. If you require further clarification, please do not hesitate to call. Sincerely, IBI Group Xxxxx Xxxxxxx, RA, LEED AP BD+C Associate Director Cc: Xxx Xxxxx, Xxxxxx CSD Xxxxx Xxxx, Xxxxxx CSD Xxxxxx Xxxxxxxxxx, Xxxxxx CSD Xxxx Xxxxxx, IBI Group Accounting | IBI GROUP 00-00 Xxxxx Xxxxxx, Xxxxx 000 Xxxxxxxxxx XX 00000 XXX tel 000 000 0000 fax 000 000 0000 xxxxxxxx.xxx Rate Schedule – Effective February 1, 2022 Classification Hourly Billing Rate ARCHITECTURAL/ENGINEERING SERVICES Associate Director – Office Lead $ 285.00 Associate – Education Lead $ 215.00 Associate Director $ 175.00 Associate $ 170.00 Architect/Engineer III $ 145.00 Architect/Engineer II $ 140.00 Architect/Engineer I $ 1...
