Plant and Materials. 4.3.1 Specifications N/A 4.3.2 Correction of defects N/A
Plant and Materials. The Contractor ensures that all Plant and Materials, services and work supplied in terms of this contract conform to all applicable environmental legislation and in the Contractor’s residing country and to the Employer’s environmental specifications. The Contractor ensures that the Employer’s chemical restrictions and controls at Koeberg (CRACK) programme (KAA-751) are adhered to.
Plant and Materials. If this Sub-Clause applies, Interim Payment Certificates shall include, under sub-
Plant and Materials. 4.3.1 Specifications ................................................................................................................................. 4.3.2 Correction of Defects .....................................................................................................................
Plant and Materials. 4.1 Specifications The contractor shall adhere to the following standards listed below: • Occupational Health and Safety Act: Act 85 of 1993 and its Regulations. • Generation Plant Safety Regulations 36-681 • Supplier Contract Quality Requirements Specification (QM58) • Duvha Power Station Contractors Safety Manual (SAS 0012) • Work in Confined Spaces (SAP0006) Criteria for environmental monitoring of work (SAI 0082) Rodding of dust hoppers
Plant and Materials. 4.3.1 Quality Sub clause 2.5. Quality Assurance Requirements above refers. All imported Plant and Materials are new and of merchantable quality, to a recognised national standard, with all proprietary products installed to manufacturers’ instructions. The Contractor replaces any damaged Plant and Materials (whether in the Working Areas or not) or any Plant and Materials with Defects and notifies the Project Manager and the Supervisor each time replacement is required. Comment [A5]: Xxxxxx/Themba, please update based on the list of Pl and Material you have.
Plant and Materials. Specifications The Contractor shall use only tools and test equipment relevant to the operation, repair and maintenance of the contracted equipment. All test equipment used shall be calibrated against relevant standards to ensure accurate measurement results at all times. Proof of calibration certificates needs to be issued on request by the Service Manager. All tools used shall be safe and in good working conditions. All electrical tools shall be properly insulated to alleviate electrocution risk. All tools used needs to be inspected and recorded in the tool inspection sheet. The Service Manager reserves the right to have access to the maintenance records of the Contractor’s plant and equipment, when requested. Only materials with acceptable quality must be used as part of the services. Where an industry norm certification (SABS, expiry date, etc.) cannot be determined, then the Service Manager must be afforded the opportunity to inspect and authorise the items prior to it being delivered onto ACSA premises.
Plant and Materials. (1) The Contractor is to provide storage for safekeeping of plant and material for execution of the works.
Plant and Materials. Quality Quality is usually designed in or specified in the technical specifications referred to in section 6 of this Works Information.
Plant and Materials. Plant & Materials provided “free issue” by the Employer No Plant is provided “free issue” to the Contractor for this Contract. All Plant is to be provided by the Contractor. Certain Materials are provided “free issue” to the Contractor – refer to Xxxx of Quantities and 6 (Services and other things provided by the Employer) hereunder.
