IRE Sample Clauses

IRE. Black edges on the image will be measured as program blanking, and may result in blanking measurements being wide. Composite video white levels should not exceed 100 IRE units, and program black levels should not extend below 7.5 IRE units. Neither the program luminance whites nor blacks should be clipped excessively. Composite chroma levels should not exceed 110 IRE and may be clipped to prevent transmission over modulation. Discovery standards do not distinguish between shows of digital component origination or those of composite origination when evaluating encoded chrominance levels. If digital production methods are used, it is the responsibility of the vendor to ensure that the encoded signal meets the composite guidelines. All programs will be judged against these analog composite guidelines, irrespective of their native origination. NTSC composite gamut legality is also required of all programs, irrespective of origination. Horizontal and vertical synchronizing pulses, where applicable, must be recorded in the program tape at a level of -40 IRE. Each program shall be preceded with a minimum of 1 minute of SMPTE or EIA color bars (75% chroma amplitude) and a reference tone of 1000 or 400 Hz, followed by a 15 second slate, a countdown and 2 seconds of black before start of program. The tape must have a minimum of 30 seconds of black following the last program picture and audio. The program material must be representative of the audio and video reference signals.
AutoNDA by SimpleDocs
IRE. The minimum unweighted signal to noise ratio shall be 50 dB. · Graphic Overlays should not exceed 100 IRE over the program video of 100 IRE. PROMOS (Not Applicable)

Related to IRE

  • SBC-13STATE shall provide to CLEC Interconnection of the Parties’ facilities and equipment for the transmission and routing of Telephone Exchange Service traffic and Exchange Access traffic pursuant to the applicable Appendix ITR, which is/are attached hereto and incorporated herein by reference. Methods for Interconnection and Physical Architecture shall be as defined in the applicable Appendix NIM, which is/are attached hereto and incorporated herein by reference.

  • Connectivity User is solely responsible for providing and maintaining all necessary electronic communications with Exchange, including, wiring, computer hardware, software, communication line access, and networking devices.

  • AT&T-13STATE will not block switched access traffic delivered to any AT&T-13STATE Access Tandem Switch or Local/Access Tandem Switch for completion on CLEC’s network. The Parties understand and agree that Meet Point trunking arrangements are available and functional only to/from switched access customers who directly connect with any AT&T-13STATE Access Tandem Switch or Local/Access Tandem Switch that CLEC’s switch subtends in each LATA. In no event will AT&T-13STATE be required to route such traffic through more than one of its Tandem Switches for connection to/from switched access customers. AT&T-13STATE shall have no responsibility to ensure that any switched access customer will accept traffic that CLEC directs to the switched access customer.

  • Telecommunications Each Lender and Administrative Agent shall be entitled to rely on the authority of any individual making any telecopy, electronic or telephonic notice, request, or signature without the necessity of receipt of any verification thereof.

  • ELECTRICAL SERVICES A. Landlord shall provide electric power for a combined load of 3.0 xxxxx per square foot of useable area for lighting and for office machines through standard receptacles for the typical office space.

  • Electrical Service Electrical service for new construction or a renovated existing building shall be 480/277-volt, 3-phase, 4-wire or approved equal. Service shall be sized for HVAC and other mechanical system(s) loads, lighting, general building services, and dedicated computer based office equipment loads. 5 xxxxx per square foot shall be provided for lighting and general service receptacles. Size of neutral conductor of 3- phase circuits shall be twice that of phase conductor to accommodate potential harmonic currents associated with computer system electronic power supplies and fluorescent lighting fixtures electronic ballasts. An adequately sized 3 phase “wye” wound step down transformer shall be provided to supply 208/120-volt, 3 phase power, for lighting, general service receptacles and dedicated computer based office equipment. Dedicated, isolated ground circuits shall be supplied from separate isolated ground power distribution panel(s). Lighting circuits shall be supplied from separate lighting panel(s). Panels shall have 20% spare capacity and be complete with 10% spare breakers of each size, but no less than 1 spare. No more than 4 duplex receptacles shall be connected to any single 20-amp dedicated isolated ground circuit or general service circuit.

  • Systems The details of any systems work will be determined after a thorough business analysis. System's work will be billed on a time and material basis. Investors Bank provides an allowance of 10 systems hours for data extract set up and reporting extract set up. Additional hours will be billed on a time and material basis.

  • Signaling Link Transport 9.2.1 Signaling Link Transport is a set of two or four dedicated 56 kbps transmission paths between Global Connection-designated Signaling Points of Interconnection that provide appropriate physical diversity.

  • Small and medium-sized enterprises 1. The Parties will promote a favourable environment for the development of the small and medium enterprises (SME) on the basis of strengthening of the relevant private and governmental bodies, as well as the exchange of experiences and good practices with the SME. 2. Cooperation shall include, among other subjects: (a) the designing and development of mechanisms to encourage partnership and productive chain linkage development; (b) development of human resources and management skills to increase the knowledge of the Chinese and Peruvian markets; (c) defining and developing methods and strategies for clusters development; (d) increasing access to information regarding mandatory procedures and any other relevant information for an SME exporter; (e) defining technological transference: programs oriented to transfer technological innovation to SME and to improve their productivity; (f) increasing access to information on technological promotion programs for SME and financial support and encouragement programs for SME; (g) supporting new exporting SME (sponsorship, credits and guarantees, seed capital); and (h) encouraging partnership and information exchange for SME financing institutions (credits, banks, guarantee organizations, seed capital firms). 3. Cooperation shall be developed, among other activities, through: (a) information exchange; (b) conferences, seminars, experts dialogue and training programs with experts; and (c) promoting contacts between economic operators, encouraging opportunities for industrial and technical prospecting.

  • Moonlighting 24.01 The Company and the Union agree in principle to eliminate the practice commonly referred to as moonlighting.

Time is Money Join Law Insider Premium to draft better contracts faster.