Inside Wire Provision Clause Samples

Inside Wire Provision. If Association controls wiring between the Demarcs and the wall jacks inside the Unit, the Association shall provide and maintain its wire, cable, and connector jacks from the Demarcs to the wall jacks in the Residential Dwelling Units (“Inside Wire”) and while AT&T is using a specific portion of Inside Wire within a Residential Dwelling Unit to provide an AT&T Service, allow AT&T to be the only user of such portion of Inside Wire. Association may allow another provider to use an unused portion of Inside Wire at the Property to serve an End User that is a subscriber to multiple providers. AT&T's provision of the Bulk Services to all or any portion of the Property is subject to AT&T’s technical evaluation to determine whether the Inside Wire meets the following minimum specifications. AT&T shall have no obligation to provide AT&T Services where the Inside Wire does not meet AT&T’s minimum wiring specifications required to accommodate provision of such AT&T Service as listed below. Association understands and acknowledges that pursuant to 47 C.F.R. § 64.105, Association may establish separate demarcation points for each customer at the Property, or a single demarcation point for all customers for the entire premises. Association desires and elects that AT&T establish multiple demarcation points at each customer’s premises (i.e., unit) on the property (i.e., multi-unit premises), with each demarcation point no further inside the customer’s premises than 12 inches from where the wiring enters the customer’s premises, or as close thereto as practicable.