Common use of Inscriptions Clause in Contracts

Inscriptions. 2.3.1. Gas-discharge light sources submitted for approval shall bear on the cap or bulb: 2.3.1.1. the trade name or ▇▇▇▇ of the applicant; 2.3.1.2. the international designation of the relevant category; 2.3.1.3. the rated wattage; this need not to be indicated separately if it is part of the international designation of the relevant category; 2.3.1.4. a space of sufficient size to accommodate the approval ▇▇▇▇. 2.3.2. The space mentioned in paragraph 2.3.1.4. shall be indicated in the drawings accompanying the application for approval. 2.3.3. Other inscriptions than those covered by paragraphs 2.3.1. and 2.4.4. may be affixed on the cap. 2.3.4. The ballast used for the type approval of the light source shall be marked with type and trade ▇▇▇▇ identification and with the rated voltage and wattage, as indicated on the relevant lamp data sheet,

Inscriptions. 2.3.1. Gas-discharge light sources submitted for approval shall bear on the cap or bulb: 2.3.1.1. the The trade name or ▇▇▇▇ of the applicant; 2.3.1.2. the The international designation of the relevant category; 2.3.1.3. the The rated wattage; this need not to be indicated separately if it is part of the international designation of the relevant category; 2.3.1.4. a A space of sufficient size to accommodate the approval ▇▇▇▇. 2.3.2. The space mentioned in paragraph 2.3.1.4. above shall be indicated in the drawings accompanying the application for approval. 2.3.3. Other inscriptions than those covered by paragraphs 2.3.1. above and 2.4.4. below may be affixed on the cap. 2.3.4. The In case the ballast is not integrated with the light source, the ballast used for the type approval of the light source shall be marked with type and trade ▇▇▇▇ identification and with the rated voltage and wattage, as indicated on the relevant lamp data sheet,.

Inscriptions. 2.3.1. Gas-discharge light sources submitted for approval shall bear on the cap or bulb: 2.3.1.1. the trade name or ▇▇▇▇ of the applicant; 2.3.1.2. the international designation of the relevant category; 2.3.1.3. the rated wattage; this need not to be indicated separately if it is part of the international designation of the relevant category; 2.3.1.4. a space of sufficient size to accommodate the approval ▇▇▇▇mark. 2.3.2. The space mentioned in paragraph 2.3.1.4. shall be indicated in the drawings accompanying the application for approval. 2.3.3. Other inscriptions than those covered by paragraphs 2.3.1. and 2.4.4. may be affixed on the cap. 2.3.4. The ballast used for the type approval of the light source shall be marked with type and trade ▇▇▇▇ mark identification and with the rated voltage and wattage, as indicated on the relevant lamp data sheet,