Information Technology Accessibility Standards Any information technology related products or services purchased, used or maintained through this Grant must be compatible with the principles and goals contained in the Electronic and Information Technology Accessibility Standards adopted by the Architectural and Transportation Barriers Compliance Board under Section 508 of the federal Rehabilitation Act of 1973 (29 U.S.C. §794d), as amended. The federal Electronic and Information Technology Accessibility Standards can be found at: xxxx://xxx.xxxxxx-xxxxx.xxx/508.htm.
Services, Materials, and Equipment Unless otherwise specified, the Contractor shall provide and assume full responsibility for all services, materials, equipment, labor, transportation, construction equipment and machinery, tools, appliances, fuel, power, light, heat, telephone, water, sanitary facilities, temporary facilities, and all other facilities, incidentals, and services necessary for the construction, performance, testing, start-up, inspection and completion of the Work.
Regulatory Reporting Ultimus agrees to provide reports to the federal and applicable state authorities, including the SEC, and to the Funds’ Auditors. Applicable state authorities are those governmental agencies located in states in which the Fund is registered to sell shares.
Materials and Methods 86 2.1 PARTICIPANTS 87 We used baseline measurements from a convenience sample of participants in previous (3) and 88 ongoing cohort studies investigating the effects of rehabilitation on balance responses (Table 1). PD 89 participants were mild-moderate with bilateral symptoms (Xxxxx and Xxxx stage 2-3 (13)). All 90 participants provided written informed consent and all study procedures were approved by Institutional 91 Review Boards at the Georgia Institute of Technology and Emory University.
Regulatory Compliance a. Monitor compliance with the 1940 Act requirements, including:
Materials and Supplies The cost of materials and supplies is allowable. Purchases should be charged at their actual prices after deducting all cash discounts, trade discounts, rebates, and allowances received. Withdrawals from general stores or stockrooms should be charged at cost under any recognized method of pricing, consistently applied. Incoming transportation charges are a proper part of materials and supply costs.
NYS OFFICE OF INFORMATION TECHNOLOGY SERVICES NOTIFICATION All New York State Agencies must notify the Office of Information Technology Services of any and all plans to procure IT and IT -related products, materials and services meeting required thresholds defined in Technology Policy NYS–P08-001: xxxxx://xxx.xx.xxx/sites/default/files/documents/NYS-P08-001.pdf, as may be amended, modified or superseded. SALES REPORTING REQUIREMENTS Contractor shall furnish OGS with quarterly sales reports utilizing Appendix I - Report of Contract Sales. Purchases by Non- State Agencies, political subdivisions and others authorized by law shall be reported in the same report and indicated as required. All fields of information shall be accurate and complete. OGS reserves the right to unilaterally make revisions, changes and/or updates to Appendix I - Report of Contract Sales or to require sales to be reported in a different format without processing a formal amendment and/or modification. Further, additional related sales information and/or detailed Authorized User purchases may be required by OGS and must be supplied upon request. Reseller Sales Product sold through Reseller(s) must be reported by Contractor in the required Appendix I – Report of Contract Sales. Due Date The Appendix I - Report of Contract Sales will be quarterly (January - March, April - June, July - September and October - December). Reports will be due 1 month after the closing quarter. SERVICE REPORTS FOR MAINTENANCE/SUPPORT AND WARRANTY WORK Service Reports for Authorized User An Authorized User in an RFQ may require compliance with any or all of this section. If requested by the Authorized User, the Contractor shall furnish the Authorized User with service reports for all Maintenance/support and warranty work upon completion of the services. The service reports may include the following information in either electronic or hard copy form as designated by the Authorized User: Date and time Contractor was notified Date and time of Contractor’s arrival Make and model of the Product Description of malfunction reported by Authorized User Diagnosis of failure and/or work performed by Contractor Date and time failure was corrected by Contractor Type of service – Maintenance/support or warranty Charges, if any, for the service Service Reports for OGS
Research Use Reporting To assure adherence to NIH GDS Policy, the PI agrees to provide annual Progress Updates as part of the annual Project Renewal or Project Close-out processes, prior to the expiration of the one (1) year data access period. The PI who is seeking Renewal or Close-out of a project agree to complete the appropriate online forms and provide specific information such as how the data have been used, including publications or presentations that resulted from the use of the requested dataset(s), a summary of any plans for future research use (if the PI is seeking renewal), any violations of the terms of access described within this Agreement and the implemented remediation, and information on any downstream intellectual property generated from the data. The PI also may include general comments regarding suggestions for improving the data access process in general. Information provided in the progress updates helps NIH evaluate program activities and may be considered by the NIH GDS governance committees as part of NIH’s effort to provide ongoing stewardship of data sharing activities subject to the NIH GDS Policy.
CERTIFICATION OF NO ASBESTOS CONTAINING MATERIALS OR WORK 8.1 The Contractor shall be responsible for ensuring that no asbestos containing materials or work is included within the scope of the Work. The Contractor shall take whatever measures it deems necessary to insure that all employees, suppliers, fabricators, material men, subcontractors, or their assigns, comply with this requirement.
