Good Electricity Industry Practice Sample Clauses

Good Electricity Industry Practice. 11.1 Western Power* must comply with Good Electricity Industry Practice* Western Power* must comply with Good Electricity Industry Practice* when providing Services* and performing its obligations under this Contract*.
AutoNDA by SimpleDocs
Good Electricity Industry Practice. 3.2 Despite clause 3.1, PRE is not in breach of this Agreement if it is not (acting reasonably) able to provide a Metering Service:
Good Electricity Industry Practice. ElectraNet warrants that the Services will be provided in accordance with good electricity industry practice.
Good Electricity Industry Practice. Except to the extent a relevant standard is expressly or impliedly provided under a Licence, the National Electricity Rules or the Distribution Code or other relevant code as a standard equal to or above which an obligation should be fulfilled, each Party must fulfil its obligations under this Agreement in accordance with good electricity industry practice. Coordinated equipment replacement Without limiting clause 4.6(b) the Parties must co-operate in replacing and in adjusting both primary (high voltage) equipment and secondary (control, communication and protection systems) equipment where specific compatibility must be maintained to ensure both Parties remain satisfied that intended functionality is maintained. Specifically, a Party must replace its equipment at its own cost in order to maintain compatibility and co-ordinated functionality with the other Party’s equipment, provided that: the other Party is replacing existing functionality and not augmenting capability or service levels; the other Party is undertaking such replacement to maintain compliance with good electricity industry practice; and where a Party intends replacing any of its equipment, and where that Party acting reasonably could determine that clause 4.6(a) may require the other Party to also replace equipment, then the intending Party must give sufficient notice to the other Party of the intended equipment replacement to allow the other Party reasonable time to meet its obligations under clause 4.6(a). Consistent with clause 5.3, either Party may notify the other Party of any safety concern that requires remedial action or equipment changes. The notifying Party must specify the nature of the concern, and the required action. Upon the receipt of notice of a safety concern as provided under clause 4.6(c) the notified Party must act promptly to undertake the remedial action or equipment changes in accordance with the required action stated in the notice. The notified Party must undertake all such remedial actions and equipment changes at its own expense. If the notified Party has been obliged to act under clause 4.6(d) but disputes the validity of the safety concerns as set out in the notice, then the notified Party may subsequently make use of the dispute provisions as provided in clause 26 of this Agreement. If the dispute provisions determine that the required action set out in the notice was not justifiable by the safety concern raised in the notice, then the notifying Party will be...
Good Electricity Industry Practice. 21 10.1 Western Power* must comply with Good Electricity Industry Practice* 21
Good Electricity Industry Practice. Microgrid Operator must comply with Good Electricity Industry Practice
Good Electricity Industry Practice has the same meaning as "good electricity industry practice" as defined in section 1.3 of the ENAC 2004.
AutoNDA by SimpleDocs
Good Electricity Industry Practice. 15.16.1 The Company shall conduct the Project in accordance with Good Electricity Industry Practice.
Good Electricity Industry Practice. Currently in the general obligations, Clause 2.1 of the draft DDA sets out that that Purpose of the clause is intended to provide an overview of each party’s obligations under this Agreement, and does not impose any legal obligations on either party. In the comparable clauses in both Unison and Vector negotiated contracts (clauses 2.1 and 2.2), the services and obligations of the trader and distributor are framed with reference to Good Electricity Industry Practice: 2 As viewed at xxxxx://xxx.xxxxxxx.xxx.xx/the-privacy-act-and-codes/privacy-act-and-codes-introduction
Good Electricity Industry Practice. Western Power must comply with Good Electricity Industry Practice‌ Western Power must comply with Good Electricity Industry Practice when providing Services and performing its obligations under this Contract. User must comply with Good Electricity Industry PracticeThe User must comply with Good Electricity Industry Practice in using the Services and performing its obligations under this Contract.
Time is Money Join Law Insider Premium to draft better contracts faster.