Gatherer Equipment Sample Clauses

Gatherer Equipment. Gatherer shall, at its sole cost and expense, procure, install, construct, own, operate and maintain measurement facilities to measure Produced Water at each Measurement Point and Redelivery Point (except as provided in Section 4.1(d) of the Agreement), in accordance with Good Operating Practices for custody transfer measurement, including the testing of such facilities no less than Monthly. Gatherer will install SCADA for real time monitoring of instantaneous flow rates and pipeline pressures, with access to the data available to Producer. Gatherer will install a shut-in/throttling valve at the Measurement Points that will be connected via telemetry or hard-wire and shall be activated in cases of events or anticipated events at the System that may require a reduction or elimination of water flow into the Measurement Points, including but not limited to instantaneous flow rates and pipeline pressures that exceed or are expected to exceed the Maximum Delivery Point Pressure, high tank level events, pump failure, loss of electricity, or other potential events that negatively impact the System. Gatherer will, if requested by Producer, provide Producer with real-time electronically transmitted data via telemetry or hard-wire transmission related to the System at and immediately downstream of the Measurement Points, including line pressures, volumetric flow rates, and any other data that is necessary for the safe and efficient operation of Producer’s equipment and facilities upstream of the Measurement Points and that Producer reasonably requests.
Sample 1Sample 2
AutoNDA by SimpleDocs

Related to Gatherer Equipment

  • Customer Equipment Customer represents and warrants that it owns or has the legal right and authority, and will continue to own or maintain the legal right and authority during the term of this Agreement, to place and use the Customer Equipment as contemplated by this Agreement. Customer further represents and warrants that its placement, arrangement, and use of the Customer Equipment in the Internet Data Centers complies with the Customer Equipment Manufacturer's environmental and other specifications.

  • Computer Equipment No computers and/or personal electronic devices, such as tablets and laptop computers, or any component thereof, may be purchased with funds provided under this Contract, regardless of purchase price, without prior written approval of ADMINISTRATOR. Any such purchase shall be in accordance with specifications provided by ADMINISTRATOR, be subject to the same inventory control conditions specified in Subparagraphs 19.1.1 to 19.1.4, and, at the sole discretion of ADMINISTRATOR, become the property of COUNTY upon termination of this Contract.

  • Metering Equipment 13.01. Utility will furnish, install, own and maintain metering equipment capable of measuring the flow of kilowatt-hours (kWh) of energy. The Customer's service associated with the CRG will be metered at a single metering point. The metering equipment will measure energy delivered by Utility to Customer and also measure energy delivered by Customer to Utility. Customer agrees to provide safe and reasonable access to the premises for installation of this equipment and its future maintenance or removal.

  • Other Equipment Seller shall install, own and maintain the infrastructure associated with the Revenue Metering Package, including but not limited to all enclosures (meter cabinets, meter pedestals, meter sockets, pull boxes, and junction boxes, along with their grounding/bonding connections), CT/PT mounting structures, conduits and ductlines, enclosure support structures, ground buses, pads, test switches, terminal blocks, isolation relays, telephone surge suppressors, and analog phone lines (one per meter), subject to Company's review and approval.

  • Contractor’s Equipment Payment for required equipment owned by the Construction Manager or an affiliate of the Construction Manager will be based solely on an hourly rate derived by dividing the current appropriate monthly rate by 176 hours. No payment will be made under any circumstances for repair costs, freight and transportation charges, fuel, lubricants, insurance, any other costs and expenses, or overhead and profit. Payment for such equipment made idle by delays attributable to the Government will be based on one-half the derived hourly rate under this subsection.

  • Your Equipment All equipment and facilities provided by you for use with your Services is “Customer Equipment.” You are solely responsible for installing, maintaining, configuring, repairing, replacing, upgrading and using your Customer Equipment. Astound has no responsibility whatsoever with respect to your Customer Equipment. If your Customer Equipment impairs the Services, you will remain liable for payment of the applicable Fees for your Services. If, at your request, Xxxxxxx should attempt to resolve difficulties caused by your Customer Equipment, such efforts will be performed at Astound’s discretion and at Astound’s then- current standard hourly rates for such work. Any Customer Equipment you use in connection with the Services must meet Astound’s then-current minimum technical and other requirements.

  • Computer Equipment Recycling Program If this Contract is for the purchase or lease of computer equipment, then Contractor certifies that it is in compliance with Subchapter Y, Chapter 361 of the Texas Health and Safety Code related to the Computer Equipment Recycling Program and the Texas Commission on Environmental Quality rules in 30 TAC Chapter 328.

  • Interconnection Facilities 4.1.1 The Interconnection Customer shall pay for the cost of the Interconnection Facilities itemized in Attachment 2 of this Agreement. The NYISO, in consultation with the Connecting Transmission Owner, shall provide a best estimate cost, including overheads, for the purchase and construction of its Interconnection Facilities and provide a detailed itemization of such costs. Costs associated with Interconnection Facilities may be shared with other entities that may benefit from such facilities by agreement of the Interconnection Customer, such other entities, the NYISO, and the Connecting Transmission Owner.

  • Interconnection Customer’s Interconnection Facilities The Interconnection Customer shall design, procure, construct, install, own and/or control the Interconnection Customer’s Interconnection Facilities described in Appendix A at its sole expense.

  • New Equipment Where new types of equipment and/or operations, for which rates of pay are not established by this Agreement, are put into use after the ratification date of this Agreement within operations covered by this Agreement, rates governing such operations shall be subject to negotiations between the parties. This paragraph shall apply to all new types of equipment including office and clerical equipment. In the event agreement cannot be reached within sixty (60) days after the date such equipment is put into use, the matter may be submit- xxx to the National Grievance Committee for final disposition. Rates agreed upon or awarded shall be effective as of the date equipment is put to use.

Time is Money Join Law Insider Premium to draft better contracts faster.