Licensing Requirements The following licensing requirements shall apply when the applicable Florida Statute mandates specific licensing for Contractors engaged in the type of work covered by this solicitation.
CONTRACT REQUIREMENTS a. NSF will exercise its responsibility for oversight and monitoring of procurements, contracts or other contractual arrangements for the purchase of materials and supplies, equipment or general support services under the award. The procedures set forth below must be followed to ensure that performance, materials and services are obtained in an effective manner and in compliance with the provisions of applicable Federal statutes and executive orders. The awardee must obtain written approval from the cognizant NSF Grants and Agreements Officer prior to entering into a contract if the amount exceeds $250,000 or other amount specifically identified in the agreement. Contracts clearly identified in the NSF award budget are considered approved at the time of award unless approval is withheld by the Grants and Agreements Officer. Contracts must be clearly identified in the NSF award budget on Line G6. Other. The threshold noted above also applies to cumulative increases in the value of the contractual arrangement after initial NSF approval. The awardee must not artificially segregate its procurements to lesser dollar amounts for the purpose of circumventing this requirement. A request to enter into a contract must include, at a minimum:
Conflict of Interest Requirements 1. If Contractor is a nonprofit agency, Contractor will comply with the California Corporations Code on Non-Profit Corporations.
Subcontract Requirements As required by Section 6.22(e)(5) of the Administrative Code, Contractor shall insert in every subcontract or other arrangement, which it may make for the performance of Covered Services under this Agreement, a provision that said subcontractor shall pay to all persons performing labor in connection with Covered Services under said subcontract or other arrangement not less than the highest general prevailing rate of wages as fixed and determined by the Board of Supervisors for such labor or services.
Bonding Requirements The Contractor is required to furnish a performance bond on the form in a form acceptable to the City, in a sum of not less than [insert bonding level] of the annual amount of the contract to guarantee the faithful performance of this contract. The bond must be approved as to sufficiency and qualifications of the surety by the Controller.
COMPLIANCE WITH LICENSING REQUIREMENTS CONTRACTOR shall comply with all necessary licensing requirements and shall obtain appropriate licenses and display the same in a location that is reasonably conspicuous, as well as file copies of same with the County Executive Office.
Project Requirements Failure to comply with the following requirements will result in a suspension of all other operations:
Minimum Vendor Legal Requirements Vendor shall remain aware of and comply with this Agreement and all local, state, and federal laws governing the sale of products/services offered by Vendor under this contract. Such applicable laws, ordinances, and policies must be complied with even if not specified herein.
Equipment Requirements No Equipment is provided to Customer as part of this Service.
Support Requirements If there is a dispute between the awarded vendor and TIPS Member, TIPS or its representatives may assist, at TIPS sole discretion, in conflict resolution or third party (mandatory mediation), if requested by either party. TIPS, or its representatives, reserves the right to inspect any project and audit the awarded vendors TIPS project files, documentation and correspondence. Status of TIPS Members as Related to This Agreement TIPS Members stand in the place of TIPS as related to this agreement and have the same access to the proposal information and all related documents. TIPS Members have all the same rights under the awarded Agreement as TIPS.
