Scope of the Convention Article 1
Convention Except as otherwise provided in this Conveyance, each calendar day, month, quarter and year shall be deemed to begin at 12:01 a.m. Central Time on the stated day or on the first day of the stated month, quarter or year, and to end at 12:00 a.m. Central Time on the next day or on first day of the next month, quarter or year, respectively.
Union Conventions The chapter chairperson or his/her representative elected to attend a function of the International Union such as convention, or educational conferences, upon proper application, shall be allowed a total of five (5) days per year time off without loss of time or pay to attend such conference and/or conventions.
File Naming Conventions Files will be named according to the following convention: {gTLD}_{YYYY-‐MM-‐DD}_{type}_S{#}_R{rev}.{ext} where:
Conventions For purposes of this Article XIII, Party A means the Carrier from which a telephone number is Ported, and Party B means the carrier to which a telephone number is ported.
Day count convention Any interest, commission or fee accruing under a Finance Document will accrue from day to day and is calculated on the basis of the actual number of days elapsed and a year of 360 days or, in any case where the practice in the Relevant Interbank Market differs, in accordance with that market practice.
Attendance at Conferences and Conventions (a) The parties to this Agreement recognize that attendance or participation at conferences, conventions, symposia, workshops and other gatherings of a similar nature contributes to the maintenance of high professional standards.
Protocol The attached Protocol shall be an integral part of this Agreement.
Business Day Convention If the date on which any payment is due to be made under this Agreement shall occur on a day on which is not a Business Day, such payment shall be made in accordance with the Business Day Convention as specified in the Notes or the Indenture.
Measurements and arithmetic conventions All measurements and calculations shall be in the metric system and calculations done to 2 (two) decimal places, with the third digit of 5 (five) or above being rounded up and below 5 (five) being rounded down.