CAPACITY TEST PERIOD Sample Clauses

CAPACITY TEST PERIOD. The Capacity Test will be conducted over a minimum 4-hour operating period. As-tested plant capacity will be based on data recorded during two 60-minute intervals. Results from each of the two one-hour intervals will be corrected to the rating conditions shown in Table 2-1. The evaporative cooler effectiveness will be calculated from data taken during the test period, unless the ambient temperature and wet bulb temperatures are outside the limits specified in Section 2.3.2.2. If necessary, the Evaporative Cooler Effectiveness Testing can be performed independent of the Capacity Test at a time mutually agreeable to PECO and Tenaska. The effectiveness will be used to establish the standard condition compressor inlet temperature (CIT).
Sample 1Sample 2Sample 3
AutoNDA by SimpleDocs

Related to CAPACITY TEST PERIOD

  • Measurement Period (b) In this Agreement, unless the contrary intention appears, a reference to:

  • Number of Interest Periods There may be no more than 6 different Interest Periods for LIBOR Loans outstanding at the same time.

  • Maximum Leverage Ratio As of the last day of each fiscal quarter, the Borrower shall not permit the ratio (the "Leverage Ratio") of (i) Consolidated Funded Indebtedness to (ii) EBITDA of the Borrower and its Subsidiaries, as at the end of and for the period of four consecutive fiscal quarters ending on such day, to be greater than (i) 2.00 to 1.00.

  • Liquidity Test The Borrower will not permit the aggregate Value of the Eligible Portfolio Investments that can be converted to Cash in fewer than 10 Business Days without more than a 5% change in price to be less than 10% of the Covered Debt Amount for more than 30 Business Days during any period when the Adjusted Covered Debt Balance is greater than 90% of the Adjusted Borrowing Base.

  • Cash Flow Leverage Ratio The Borrower will not permit the Cash Flow Leverage Ratio on the last day of any fiscal quarter to exceed 3.50 to 1.00.

  • Maximum Secured Leverage Ratio As of the last day of any fiscal quarter, the Secured Leverage Ratio to exceed forty percent (40%);

  • Minimum Interest Coverage Ratio The Borrowers shall not permit the Interest Coverage Ratio, calculated as of the end of each fiscal quarter for the four fiscal quarters then ended, to be less than 3.50 to 1.00.

  • Adjusted Leverage Ratio The Borrower shall not permit the Adjusted Leverage Ratio as at the end of any Fiscal Quarter to be greater than the following for the respective periods set forth below: Period Adjusted Leverage Ratio Closing Date to and including March 27, 2004 3.75:1.00 March 28, 2004 to and including June 26, 2004 4.75:1.00 June 27, 2004 to and including July 2, 2005 5.60:1:00 July 3, 2005 and any time thereafter 5.25:1.00

  • Minimum Fixed Charge Coverage Ratio The Borrowers shall not permit the Fixed Charge Coverage Ratio to be less than 1.05 to 1.00, measured as of the last day of each Fiscal Quarter for the prior four fiscal quarters subject to adjustments to such measurement period as set forth in the definition of Fixed Charge Coverage Ratio.

  • Interest Coverage Ratio The Borrower will not permit the Interest Coverage Ratio to be less than 2.75 to 1.0 on the last day of any Fiscal Quarter.

Time is Money Join Law Insider Premium to draft better contracts faster.