Goals & Objectives 1. The goal of this Agreement is (INSERT GOAL(S) OF AGREEMENT).
Performance Testing 7.2.1 The Design-Builder shall direct and supervise the tests and, if necessary, the retests of the Plant using Design-Builder’s supervisory personnel and the Air Emissions Tester shall conduct the air emissions test, in each case, in accordance with the testing procedures set forth in Exhibit A (the “Performance Tests”), to demonstrate, at a minimum, compliance with the Performance Guarantee Criteria. Owner is responsible for obtaining Air Emissions Tester and for ensuring Air Emissions Tester’s timely performance. Design-Builder shall cooperate with the Air Emissions Tester to facilitate performance of all air emissions tests. Design-Builder shall not be held responsible for the actions of Owner’s employees and third parties involved in the Performance Testing, including but not limited to Air Emissions Tester.
Performance Targets Threshold, target and maximum performance levels for each performance measure of the performance period are contained in Appendix B.
Performance Measurement Satisfactory performance of this Contract will be measured by:
Performance Measure The specific representation of a process or outcome that is relevant to the assessment of performance; it is quantifiable and can be documented
Mileage Measurement Where required, the mileage measurement for LIS rate elements is determined in the same manner as the mileage measurement for V&H methodology as outlined in NECA Tariff No. 4.
Program Objectives Implement a rigorous constructability program following The University of Texas System, Office of Facilities Planning and Construction Constructability Manual. Identify and document project cost and schedule savings (targeted costs are 5% of construction costs). Clarification of project goals, objectives.
PERFORMANCE MEASUREMENTS Upon a particular Commission’s issuance of an Order pertaining to Performance Measurements in a proceeding expressly applicable to all CLECs generally, BellSouth shall implement in that state such Performance Measurements as of the date specified by the Commission. Performance Measurements that have been Ordered in a particular state can currently be accessed via the internet at xxxx://xxxx.xxxxxxxxx.xxx. The following Service Quality Measurements (SQM) plan as it presently exists and as it may be modified in the future, is being included as the performance measurements currently in place for the state of Tennessee. At such time that the TRA issues a subsequent Order pertaining to Performance Measurements, such Performance Measurements shall supersede the SQM contained in the Agreement. BellSouth Service Quality Measurement Plan (SQM) Tennessee Performance Metrics Measurement Descriptions Version 2.00 Issue Date: July 1, 2003 Introduction
Performance Tests Contractor shall perform Performance Tests in accordance with Section 11.2 of the Agreement and Attachment S.
Metrics The DISTRICT and PARTNER will partake in monthly coordination meetings at mutually agreed upon times and dates to discuss the progress of the program Scope of Work. DISTRICT and PARTNER will also mutually establish criteria and process for ongoing program assessment/evaluation such as, but not limited to the DISTRICT’s assessment metrics and other state metrics [(Measures of Academic Progress – English, SBAC – 11th grade, Redesignation Rates, mutually developed rubric score/s, student attendance, and Social Emotional Learning (SEL) data)]. The DISTRICT and PARTNER will also engage in annual review of program content to ensure standards alignment that comply with DISTRICT approved coursework. The PARTNER will provide their impact data based upon these metrics.