Computer Equipment Recycling Program Sample Clauses

Computer Equipment Recycling Program. If this Contract is for the purchase or lease of computer equipment, then Contractor certifies that it is in compliance with Subchapter Y, Chapter 361 of the Texas Health and Safety Code related to the Computer Equipment Recycling Program and the Texas Commission on Environmental Quality rules in 30 TAC Chapter 328.
Sample 1Sample 2Sample 3See All (736)
AutoNDA by SimpleDocs
Computer Equipment Recycling Program. Vendor hereby certifies its compliance with the Manufacturer Responsibility and Consumer Convenience Computer Equipment Collection and Recovery Act located in Subchapter Y, Chapter 361, Texas Health and Safety Code and the Texas Commission on Environmental Quality rules, 30 TAC, Chapter 328. Failure of a Vendor to provide this certification shall render the Vendor ineligible to participate in the bidding process. TWC shall reject the related bid and not evaluate it.
Sample 1Sample 2Sample 3See All (6)
Computer Equipment Recycling Program. Contractor certifies its compliance with Subchapter Y, Chapter 361 of the Texas Health and Safety Code and the Texas Commission on Environmental Quality rules in 30 TAC Chapter 328.
Sample 1Sample 2Sample 3See All (6)

Related to Computer Equipment Recycling Program

  • Television Equipment Recycling Program If this Contract is for the purchase or lease of covered television equipment, then Contractor certifies that it is compliance with Subchapter Z, Chapter 361 of the Texas Health and Safety Code related to the Television Equipment Recycling Program.

  • Television Equipment Recycling If this Contract is for the purchase or lease of covered television equipment, then Contractor certifies that it is compliance with Subchapter Z, Chapter 361 of the Texas Health and Safety Code related to the Television Equipment Recycling Program.

  • Testing of Metering Equipment Connecting Transmission Owner shall inspect and test all of its Metering Equipment upon installation and at least once every two (2) years thereafter. If requested to do so by NYISO or Developer, Connecting Transmission Owner shall, at Developer’s expense, inspect or test Metering Equipment more frequently than every two (2) years. Connecting Transmission Owner shall give reasonable notice of the time when any inspection or test shall take place, and Developer and NYISO may have representatives present at the test or inspection. If at any time Metering Equipment is found to be inaccurate or defective, it shall be adjusted, repaired or replaced at Developer’s expense, in order to provide accurate metering, unless the inaccuracy or defect is due to Connecting Transmission Owner’s failure to maintain, then Connecting Transmission Owner shall pay. If Metering Equipment fails to register, or if the measurement made by Metering Equipment during a test varies by more than two percent from the measurement made by the standard meter used in the test, Connecting Transmission Owner shall adjust the measurements by correcting all measurements for the period during which Metering Equipment was in error by using Developer’s check meters, if installed. If no such check meters are installed or if the period cannot be reasonably ascertained, the adjustment shall be for the period immediately preceding the test of the Metering Equipment equal to one-half the time from the date of the last previous test of the Metering Equipment. The NYISO shall reserve the right to review all associated metering equipment installation on the Developer’s or Connecting Transmission Owner’s property at any time.

  • School Improvement Plans The School shall develop and implement a School Improvement Plan as required by section 1002.33(9)(n), Florida Statutes and applicable State Board of Education Rules or applicable federal law.

Time is Money Join Law Insider Premium to draft better contracts faster.