Drinking Water Standards definition

Drinking Water Standards means all drinking water requirements set forth in the California Safe Drinking Water Act (section 116275 et. seq. Health and Safety Code) and the regulations adopted by the Department pursuant thereto.
Sample 1Sample 2Sample 3
Drinking Water Standards means safe drinking water standards established by the environmental protection agency under this chapter or established by the United States environmental protection agency under the Safe Drinking Water Act.
Sample 1Sample 2Sample 3
Drinking Water Standards means safe drinking water standards established by OEPA under the Safe Drinking Water Law or by the United States Environmental Protection Agency under the Safe Drinking Water Act. (Sec. 6109.35(A).)
Sample 1Sample 2

Examples of Drinking Water Standards in a sentence

  • Drinking water standards are most often exceeded for TDS, fluoride, and boron content.

  • Drinking water standards are established to protect consumers of drinking water from both adverse health effects (primary drinking water standards) and from qualities that make the water unpalatable (secondary drinking water standards).

  • Drinking water standards, water requirements, basic unit operations and unit processes for surface water treatment, distribution of water.

  • Drinking water standards were compared with the PECs to provide an indication of the removal efficiency that might be required to produce drinking water.

  • Drinking water standards are governed through federal regulations promulgatedthrough the SDWA.170 Thus, any reliance on aquifer storage must necessarily consider theimplications water quality treatment has on implementing such storage.

  • Drinking water standards to be corrected as per IS:10500 in place of IS:2286 as mentioned in the presentation.

  • Drinking water standards have not yet been developed for these categories of manmade compounds.

  • Drinking water standards established in these regulations are applicable to water systems required to monitor for the various contaminants.

  • By the induction hypothesis (part 2a) on the smaller simple type B1− and the derivations D1 and D2, we find thatΓ € {M 1/x}B−1 M 0 ⇐ {M 1/x}B1− B2[q] (∗)By induction hypothesis (part 2i) on the smaller simple type B−2 , the fact (∗), and the derivation D3, deduceΓ € [{M 1/x}B1− M 0|S1]B2− ⇒ A[p]But by definition of reduction we can read off that [M|S]B− = [(λx.M 0)|(M 1; S1)]B1−→B2− = [{M 1/x}B1− M 0|S1]B−2so we are done.Case: Part 2i, with M atomic, of the form R.

  • Drinking water standards are regulations that EPA sets to control the level of contaminants in the nation's drinking water.


More Definitions of Drinking Water Standards

Drinking Water Standards means drinking water rules adopted by the
Sample 1Sample 2
Drinking Water Standards means the primary and secondary maximum contaminant level standards established under the Federal Safe Drinking Water Act, 42 U.S.C. §300f et seq., and the Illinois Safe Drinking Water Act, and the regulations adopted pursuant thereto.
Sample 1Sample 2
Drinking Water Standards means saEe drinking water
Sample 1

Related to Drinking Water Standards

  • Clean water standards, as used in this clause, means any enforceable limitation, control, condition, prohibition, standard, or other requirement promulgated under the Water Act or contained in a permit issued to a discharger by the Environmental Protection Agency or by a State under an approved program, as authorized by Section 402 of the Water Act (33 U.S.C. § 1342), or by local government to ensure compliance with pre-treatment regulations as required by Section 307 of the Water Act (33 U.S.C. § 1317).

  • Drinking water means water that meets criteria as specified in 40 CFR 141 National Primary Drinking Water Regulations. "Drinking water" is traditionally known as "potable water." "Drinking water" includes the term "water" except where the term used connotes that the water is not potable, such as "boiler water," "mop water," "rainwater," "wastewater," and "nondrinking" water.

  • Clean air standards, as used in this clause, means:

  • Safe Drinking Water Act means Tit. XIV of the federal Public Health Service Act, commonly known as the “Safe Drinking Water Act”, 42 U.S.C. §300f et seq., as amended by the Safe Drinking Water Amendments of 1996, Pub. L. No. 104-182, as amended.

  • Underground source of drinking water means an aquifer or its portion:

  • Clean Air Act or “Act” means the federal Clean Air Act, 42 U.S.C. §§ 7401-7671q, and its implementing regulations.

  • Water quality standards means provisions of state or federal law which consist of a designated use or uses for the waters of the Commonwealth and water quality criteria for such waters based upon such uses. Water quality standards are to protect the public health or welfare, enhance the quality of water and serve the purposes of the State Water Control Law (§ 62.1-44.2 et seq. of the Code of Virginia) and the federal Clean Water Act (33 USC § 1251 et seq.).

  • National Ambient Air Quality Standards or “NAAQS” means national ambient air quality standards that are promulgated pursuant to Section 109 of the Act, 42 U.S.C. § 7409.

  • Air Act, as used in this clause, means the Clean Air Act (42 U.S.C. 7401 et seq.).

  • Fungicide means any substance or mixture of substances intended for preventing, destroying, repelling or mitigating any fungi.

  • Water Act, as used in this clause, means Clean Water Act (33 U.S.C. 1251 et seq.).

  • Applicable water quality standards means all water quality standards to which a discharge is subject under the federal Clean Water Act and which has been (a) approved or permitted to remain in effect by the Administrator following submission to the Administrator pursuant to Section 303(a) of the Act, or (b) promulgated by the Director pursuant to Section 303(b) or 303(c) of the Act, and standards promulgated under (APCEC) Regulation No. 2, as amended.

  • Clean Water Act or “CWA" means the federal Clean Water Act (33 U.S.C §1251 et seq.), formerly referred to as the Federal Water Pollution Control Act or Federal Water Pollution Control Act Amendments of 1972, Public Law 92-500, as amended by Public Law 95-217, Public Law 95-576, Public Law 96-483, and Public Law 97-117, or any subsequent revisions thereto.

  • Occupational Health and Safety Act means the Occupational Health and Safety Act, 1993 (Act No 85 of 1993);

  • Federal Clean Air Act means Chapter 85 (§ 7401 et seq.) of Title 42 of the United States Code.

  • Solid Waste Disposal Site means, as defined in NCGS 130A-290(a)(36), any place at which solid wastes are disposed of by incineration, sanitary landfill, or any other method.

  • Water quality means the physical characteristics of water within shoreline jurisdiction, including water quantity, hydrological, physical, chemical, aesthetic, recreation-related, and biological characteristics. Where used in this chapter, the term "water quantity" refers only to development and uses regulated under this chapter and affecting water quantity, such as impermeable surfaces and storm water handling practices. Water quantity, for purposes of this chapter, does not mean the withdrawal of ground water or diversion of surface water pursuant to RCW 90.03.250 through 90.03.340.

  • Flea and tick insecticide means any insecticide product that is designed for use against fleas, ticks, their larvae, or their eggs. “Flea and Tick Insecticide” does not include products that are designed to be used exclusively on humans or animals and their bedding.

  • Ambient air quality standard means an established concentration, exposure time, and frequency of occurrence of air contaminant(s) in the ambient air which shall not be exceeded.

  • New Jersey Stormwater Best Management Practices (BMP) Manual or “BMP Manual” means the manual maintained by the Department providing, in part, design specifications, removal rates, calculation methods, and soil testing procedures approved by the Department as being capable of contributing to the achievement of the stormwater management standards specified in this chapter. The BMP Manual is periodically amended by the Department as necessary to provide design specifications on additional best management practices and new information on already included practices reflecting the best available current information regarding the particular practice and the Department’s determination as to the ability of that best management practice to contribute to compliance with the standards contained in this chapter. Alternative stormwater management measures, removal rates, or calculation methods may be utilized, subject to any limitations specified in this chapter, provided the design engineer demonstrates to the municipality, in accordance with Section IV.F. of this ordinance and N.J.A.C. 7:8-5.2(g), that the proposed measure and its design will contribute to achievement of the design and performance standards established by this chapter.