Examples of Description Section in a sentence
Despite Condition 2.1, the Company shall not make Modifications to the Facility that are outside the scope of the intended operations of the Facility as described in the Description Section.
If the net acres specified in the Unit Description (Section II-A) are correct within plus or minus five percent (±5%) after the verification traverse, Contractor shall pay for the verification traverse at a rate of ten dollars ($10.00) per one hundred (100) feet of traversed boundary.
Each Unit is specifically identified by number on the Unit Description (Section II-A), corresponding Unit Map (Section II-B), and Bid Form (Section III-A).
C-02 Inspection PlotsThe Compliance Forester will install Inspection Plots to assess whether Seedlings have been Satisfactorily Planted (Clause B-09) and meet all Special Planting Requirements (Clause B-11, if applicable), according to the spacing and species requirements listed in the Unit Description (Section II-A).
This number varies between Units, and is listed in the Unit Description (Section II-A).
Average spacing may be different for each unit, or for contiguous areas within a Unit, therefore Seedlings will be planted over the Unit at the Average Spacing listed in the Unit Description (Section II-A).
All red alder, bigleaf maple, cherry, and/or other hardwood species identified in the Unit Description (Section II-A), that are both greater than four (4) feet in height and growing within twenty (20) feet of a conifer crop tree shall be cut.
The number of ‘Expected Planting Spots’ is calculated for each Inspection Plot by dividing the Total Seedlings per Acre (from the Unit Description, Section II-A) by 50 and rounding to the nearest whole number.
Satisfactorily Planted SeedlingsThe number of Satisfactorily Planted Seedlings is the number of Contractor-planted Seedlings within the Inspection Plot that meet all applicable specifications of Clause B-09, Clause B-11, and the Unit Description (Section II-A).
An ‘Unplantable Spot’ is a spot that does not meet the conditions for Preparation and Clearing, or is closer than the Minimum Spacing specified in the Unit Description (Section II-A).