Setbacks. Developer shall maintain the setbacks for the Project as shown on the Project Plans. In the event that any inconsistencies exist between the Zoning Ordinance and the setbacks established by this Agreement, then the setbacks required by this Agreement shall prevail.
Setbacks. The minimum setbacks required within the Creekside Sub Xxxx 0 Xxxxxxxxxxx Xxxx shall be as follows: (a) twenty five feet (25’) from the front of the lot;
Setbacks. All setbacks will comply with provisions of the Conditional Use Permit or PSC conditions, whichever distance is greater, see attached Exhibit B.
Setbacks. Front Yard (street garage access) Front Yard (alley garage access) Rear Yard (alley garage access) Side Yard on a Street 20 feet minimum 10 feet minimum 20 feet minimum 15 feet minimum adjacent to street Building Separation (Distance Between Buildings) Side Yard (single family detached, duplex) Side Yard (single family attached, multi-family) 15 feet 20 feet
Setbacks. Cut and fill slopes shall be set back from drainage courses a minimum of 25 feet from the top of bank. Additional setbacks may be required by other regulatory agencies such as Oregon Department of State Lands, Oregon Department of Land Conservation and Development, and Federal Emergency Management Agency. Cut and fill slopes shall be set back from site boundaries as described below: ▪ Top of Cut Slope. The top of cut slopes shall not be made nearer to a site boundary line than one fifth of the vertical height of cut with a minimum of 2 feet and a maximum of 10 feet. The setback may need to be increased for any required interceptor drains. ▪ Toe of Fill Slope. The toe of fill slope shall be made not nearer to the site boundary line than one fifth the height of the slope with a minimum of 2 feet and a maximum of 20 feet. Where a fill slope is to be located near the site boundary and the adjacent off-site property is developed, special precautions shall be incorporated in the work as the City deems necessary to protect the adjoining property from damage as a result of such grading. These precautions may include, but are not limited to: o Additional setbacks. o Provision for retaining or slough walls. o Mechanical or chemical treatment of the fill slope surface to minimize erosion. o Provisions for the control of surface waters
Setbacks. The Project may be located up to, but no less than, 100 feet from any bordering property as illustrated in Attachment A: Project Description.
Setbacks. In accordance with Section 5.D.4 of the Ordinance, the Developer may utilize setback easements with non-participating landowners to meet the setback requirements of the Ordinance and such reduced setbacks will be depicted on the Final Site Plan. The County will have the right to approve the form of easement agreements; provided that the County shall not have the right to review or approve payment terms.
Setbacks a. Front yard: 25’ minimum setback from road right of way b.Side or interior yards:
Setbacks. The minimum setbacks required within the Creekside Sub Unit 1 Development Area shall be as follows: (a) twenty five feet (25’) from the front of the lot;
