Compliance with Standards Although the standards for workmanship, material, and equipment have been selected in these specifications as a basis of reference, standards and specifications of the other bank member countries and recommendations of standards international organizations will be acceptable provided they are substantially equivalent to the designated standards and provided furthermore that the contractor submits for approval detailed specifications which he proposes to use. Reference to brand names or catalog numbers if any in these specifications have been made only for that equipment for which it has been determined that a degree of standardization is necessary to maintain certain essential features. And in certain cases such references have also been made for purposes of convenience to specify the requirements, in either case offers of alternative goods, which have similar characteristics and provide performance and quality at lease equal to those specified are acceptable. If the contractor offers materials, equipment, design calculations or tests, which conform to standards other than those specified, full details of the differences between the proposed standards and that specified in so far as they affect the design or purpose of the equipment, are to be supplied by the contractor if called upon to do so by the engineer, where required by the engineer for approval purposes, the contractor shall supply, without charge, duplicate copies of the proposed standards with English translations of the relevant portions. The contractor shall have available in his place of business (or in his supplier’s works) the relevant copies of standards or codes used for the use of the Engineer.
Compliance with Legal Requirements The grant and exercise of the Option, and any other obligations of the Company under this Agreement shall be subject to all applicable federal and state laws, rules and regulations and to such approvals by any regulatory or governmental agency as may be required. The Committee, in its sole discretion, may postpone the issuance or delivery of Shares as the Committee may consider appropriate and may require Participant to make such representations and furnish such information as it may consider appropriate in connection with the issuance or delivery of the Shares in compliance with applicable laws, rules and regulations.
COMPLIANCE WITH APPLICABLE LAWS AND STANDARDS 9.1.1 Each party must comply with all Applicable Laws in performing their obligations under this Agreement.
Compliance with Accessibility Standards All parties to this Agreement shall ensure that the plans for and the construction of all projects subject to this Agreement are in compliance with standards issued or approved by the Texas Department of Licensing and Regulation (TDLR) as meeting or consistent with minimum accessibility requirements of the Americans with Disabilities Act (P.L. 101-336) (ADA).
Compliance with Laws, Rules and Regulations Tenant, at its sole cost and expense, shall comply with all laws, ordinances, orders, rules and regulations of state, federal, municipal, or other agencies or bodies having jurisdiction over use, condition, and occupancy of the Leased Premises. Tenant must use and maintain the Leased Premises in a clean, careful, safe, and proper manner and in compliance with all Applicable Laws, including Applicable Laws pertaining to health, safety, disabled persons, and the environment; provided, however, that Tenant shall not be required to make any structural changes or repairs to the Leased Premises unless the need for such structural changes or repairs is caused by Tenant, its agents, employees, invitees, or others for whom Tenant is responsible pursuant to the terms and provisions of this Lease. Notwithstanding anything to the contrary contained elsewhere in this section, it is expressly agreed and understood that Tenant’s obligation to comply with all Applicable Laws does not apply to any violations of Applicable Laws that (a) were in effect and (b) were being violated or with which the Leased Premises was not in compliance immediately prior to the time Tenant accepted the Leased Premises, including without limitation any existing environmental contamination. Tenant will comply with the rules and regulations of the Leased Premises adopted by Landlord in its reasonable discretion. All such rules and regulations and changes and amendments thereto will be sent by Landlord to Tenant in writing and shall thereafter be carried out and observed by Tenant.
Compliance with Warning Regulations The Parties agree that Xxxxxx Xxxxxx shall be deemed to be in compliance with this Settlement Agreement by either adhering to §§ 2.3 and 2.4 of this Settlement Agreement or by complying with warning requirements adopted by the State of California’s Office of Environmental Health Hazard Assessment (“OEHHA”) applicable to the product and the exposure at issue after the Effective Date.
Compliance with Policies Each Individual Limited Partner hereby agrees that he shall comply with all policies and procedures adopted by any member of the Och-Ziff Group or which Limited Partners are required to observe by law, or by any recognized stock exchange, or other regulatory body or authority.
Compliance with Laws and Regulations A. The Parties shall comply with all applicable laws and regulations including, but not limited to, safety; security; export control; environmental; and suspension and debarment laws and regulations. Access by a Partner to NASA facilities or property, or to a NASA Information Technology (IT) system or application, is contingent upon compliance with NASA security and safety policies and guidelines including, but not limited to, standards on badging, credentials, and facility and IT system/application access.
Compliance with Governmental Directives The DS Supplier also acknowledges and agrees that the Company may need to act in response to governmental or civil authority directives which may affect DS Load. The DS Supplier agrees to cooperate with the Company in order to comply with said directives.
Compliance with Rules To comply with, and to require the Contractors to comply with, all rules, regulations, ordinances and laws bearing on the conduct of the work on the Improvements, including the requirements of any insurer issuing coverage on the Project and the requirements of any applicable supervising boards of fire underwriters.
